Jbl-synthesis SDP-25 Manuel d'utilisateur télécharger pdf (Page 13)

JBL SYNTHESIS SDP-25

SPEAKER CONFIGURATION

Speaker Conguration

Front L/R 80Hz

Center 80Hz

Side L/R 80Hz

Rear L/R 80Hz

Height L/R None

Subwoofer Yes

Back

The default crossover settings for Speaker configuration are in accordance with industry

standards. If your system has a different number of speakers or if Height speakers are used in

place of Surround Rear speakers, make the adjustments in this menu. If there are no speakers

at any position select “None” and that position will then be grayed out on other Speaker-related

menus.

To change the setting for any speaker location, first use the Up/Down Navigation Buttons to

highlight the speaker position you wish to change and press Enter. Next, use the Up/Down

Navigation Buttons again to select the crossover point for the specific speaker, which should

be listed in the speaker's Owners Manual. If the speaker is "Full Range", select "Full". For all

speaker positions other than the Front Left/Right (L/R) speakers you should select "None" if

there is no speaker at that position.

When all adjustments are complete, press Enter to return to the speaker list.

SPEAKER DISTANCE

The next critical setting is for the distance between the speakers and the primary listening

position. This is important to assure a seamless soundfield that has all audio arriving in

synchronization from one channel to the next.

Speaker Distance

Front Left 120 in

Center 120 in

Front Right 120 in

Side Left 120 in

Side Right 120 in

Rear Left 120 in

Rear Right 120 in

Height Left None

Height Right None

Subwoofer 120 in

Back

The default setting for the Speaker Distance settings is to display the distances in inches. To

display the settings in centimeters, exit the Speaker Setup menu and go back to the General

Setup Menu (See Page 10) to change the setting for Units of Measure. (See Page 10).

For optimal reproduction of surround sound content, make certain that the setting for each

available channel correctly shows the distance from the speaker to the main seating location.

To change a setting first use the Up/Down Navigation Buttons to highlight the speaker position

you wish to change and press Enter. Next, use the Up/Down Navigation Buttons again until the

correct speaker-to-listener distance is shown and press Enter. The highlight bar will return to the

list of speakers so that you may select the next speaker position to be adjusted.

Note that speaker positions where you have entered "None" in the speaker position will be

grayed out as they may not be changed.

When all adjustments are complete, press Enter to return to the Speaker Setup Menu.

The final critical adjustments are the speaker output levels.

Speaker Setup

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Jbl-synthesis SDP-25 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Acoustique Jbl-synthesis SDP-25